Doom64hunter at 20:26, 8 May 2022

2022-05-08T20:26:45Z

← Older revision		Revision as of 13:26, 8 May 2022
Line 18:		Line 18:

	// key status is unchanged		// key status is unchanged

			== Scancodes ==

			{{M32_Scancodes}}

	[[Category:Mapster32 commands]]		[[Category:Mapster32 commands]]

Doom64hunter: Created page with "ifholdkey This command will branch if the key specified by the scancode has been activated, or take the 'else' branch otherwise. Unlike ifhitkey, ifholdkey does not affect the status of the key after the block is exited. See also: ifhitkey '''Usage:''' ifholdkey KEY_F { // do stuff if key active } else { // do stuff if key inactive } // key status is un..."

2022-05-08T18:30:42Z

Created page with "ifholdkey <KEY_SC> This command will branch if the key specified by the scancode has been activated, or take the 'else' branch otherwise. Unlike ifhitkey, ifholdkey does not affect the status of the key after the block is exited. See also: ifhitkey '''Usage:''' ifholdkey KEY_F { // do stuff if key active } else { // do stuff if key inactive } // key status is un..."

New page

[[M32:ifholdkey|ifholdkey]] <KEY_SC>

This command will branch if the key specified by the scancode has been activated, or take the 'else' branch otherwise.

Unlike [[M32:ifhitkey|ifhitkey]], [[M32:ifholdkey|ifholdkey]] does not affect the status of the key after the block is exited.

See also: [[M32:ifhitkey|ifhitkey]]

'''Usage:'''
ifholdkey KEY_F
{
// do stuff if key active
}
else
{
// do stuff if key inactive
}

// key status is unchanged

[[Category:Mapster32 commands]]

M32:ifholdkey - Revision history

Doom64hunter at 20:26, 8 May 2022