Change the player's jump height

You can use the player member jumping_counter to limit the player's jump to less Olympic heights, or make the player's jump even more superhuman.

The jumping_counter increments from 0 (not jumping) to 1441 (end of jump) in increments of 180, as follows:

NOTE: In water surface sectors (LOTAG 1), the counter will only reach up to 901.

By manually setting the counter to 0 or a value above 1440 when the counter reaches one of these values, you can decrease the duration of the jump by effectively cancelling it mid-jump. Additionally, you can use a similar method to extend the jump height of the player.

You'll need a gamevar to hold the value of jumping_counter.

gamevar temp 0 2

Inside the APLAYER actor, use the following code to cut the jump duration in half:

getplayer[THISACTOR].jumping_counter temp
ifvare temp 721 
{
	setplayer[THISACTOR].jumping_counter 0 
}

If you want to increase jump height instead of lowering it, you can do this instead:

getplayer[THISACTOR].jumping_counter temp
ifvare temp 1261 
{
	setplayer[THISACTOR].jumping_counter 362 
}

The above example increases the jump duration by 5 tics. The default jumping height is 9 tics without any changes in the code. The reason 1 is added to the counter when a jump is extended is to prevent an endless jumping loop from occuring. It is recommended to check for 126x when extending the jump to maximize jumping velocity(or poszv).

Change the player's jump height

Navigation menu

Search